Defining The Configuration Mode; Calibrating The Sensors - REMEHA iSense Pro DIN AD280 Installation And Service Manual

5. Operating the appliance
0 2 4 6 8
E
1 TEMP.: 68°
2
1
D
2
# F
% $
AUTO
J I
5"
Installer level - #SYSTEM menu
Parameter Adjustment range Description
CONFIGURATION VM/MR
3WV+
0/1+V3V
OTH+3WV
0 2 4 6 8
E
1
2
1
D
2
bar
F
# 
% $
AUTO
J I
STD
45
10 12 14 16 18 20 22 24
SUNDAY 11:45
!
 :
<
STD
C002235-F-04
Operation with all Diematic control systems - No DHW priority.
Do not select this setting
Operation with Diematic-m 3 - iSense Pro control systems - DHW
priority available.
Do not select this setting
Control for an ON/OFF generator
Do not select this setting
Control for a generator by BUS OpenTherm
10 12 14 16 18 20 22 24
SUNDAY 11:45
! :
<
C002219-D-04
5.6.2.

Defining the configuration mode

1. Access the installer level: Press key - for around 5 seconds.
2. Select the menu #SYSTEM.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 36
3. Set the parameter CONFIGURATION to OTH+3WV:
5.6.3.

Calibrating the sensors

1. To access user level: Press the > key.
2. Select the menu #SETTING.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 36
3. Set the following parameters:
iSense Pro DIN - AD280
Customer setting
OTH+3WV
22/11/2012 - 300025649-001-01