Omron V680-HAM91 User Manual page 25

Access Address Setting Switch
Set the operation mode for reading data.
The position of the arrow in the figure is
the direction in which the setting is made.
Antenna Connector
Connect this connector to the V680-series Antenna.
1
2
Item
Setting Specify the memory address of the ID Tag in 4-digit hexadecimal.
method To specify an ID Tag memory address of 01A3 hex:
0
1
A
3
Setting 0000 hex to FFFF hex (See note.)
range Default setting: 0000 hex
Note: Note: The upper 8 bits are not read when FFFF hex is specified using 16-bit
read/write. Output for all will be OFF. .
Pin No. Name
1 S
2 GND
Description
Signal type
Signal line
Analog ground
RFID System
Section 2
I/O
---
---
25
User's Manual