Omron V680-HAM91 User Manual page 24

Section 2
•Write Mode Setting
Set the operation mode for writing data.
No. Name
0 2bytes WRITE
1 BIT SET
2 BIT CLEAR
3 1byte WRITE
4 -
5
6
7
8
9
Mode setting switch setting are read only when the power supply is turned ON. Therefore, settings cannot be changed
while the power is being supplied. Turn the power supply OFF before changing the settings.
RFID System
24
User's Manual
Write the 2 bytes (16 bits) of data input to the external data input (ID 0 to ID15) to the ID Tag.
When external data input (ID0 to ID15) is received, only the bit turned ON will be set (i.e., turned ON).
When external data input (ID0 to ID15) is received, only the bit turned ON will be cleared (i.e., turned OFF).
The other bits will not be changed.
Write the 1 byte (8 bits) of data input to the external data input (ID 0 to ID15) to the ID Tag.
Input for the external data input (ID 0 to ID15) will be ignored.
Note: This function is provided to support the previous model (the V600HAM91).
Setting prohibited
(An access mode setting error will occur.)
The position of the arrow in the figure is the
direction in which the setting is made.
Description