Leds - Cisco Nexus 7702 Hardware Installation Manual

LEDs

This appendix includes the following topics:
•
•
•
Supervisor Module LEDs
LED
STATUS
Supervisor Module LEDs, page 123
I/O Module LEDs, page 125
Power Supply LEDs, page 126
Color
Green
Red
Flashing red
Off
A P P E N D I X
Status
All diagnostics pass. The module is operational (normal initialization
sequence).
Indicates one of the following:
• The module has detected a slot ID parity error and will not power
on or boot up.
• The module is not fully inserted and does not have a reliable
connection to the midplane.
• The diagnostic test has failed.
Indicates one of the following:
• The inlet air temperature of the system has exceeded the safe
operating temperature limits of the module (a major
environmental warning). The module has been shut down to
prevent permanent damage. The system will be shut down after
two minutes if this condition is not cleared.
• The module is resetting, and both ejector levers are out.
The module is not receiving power.
Cisco Nexus 7702 Hardware Installation Guide
B
123