Cisco Nexus 7702 Hardware Installation Manual page 134

Supervisor Module LEDs
LED
ID
SYSTEM
ACTIVE
PWR MGMT
MGMT ETH
LINK
ACT
LOG FLASH
Cisco Nexus 7702 Hardware Installation Guide
124
Color Status
Flashing blue The operator has activated this LED to identify this module in the
chassis.
Off This module is not being identified.
Green All chassis environmental monitors are reporting okay.
Amber At least one power supply has failed or the power supply fan has failed.
Red The temperature of the supervisor engine major threshold has been
exceeded.
Off The slot has detected a slot ID parity error.
Green The supervisor module is operational and active.
Amber The supervisor module is in standby mode.
Green Sufficient power is available for all of the installed modules.
Amber Insufficient power is available for all of the installed modules.
Green The management port is operational.
Amber The management port link has been disabled through the software.
Flashing The management port link is bad and has been disabled due to a
amber hardware failure.
Off The module has not detected a signal.
Green The module has detected a link.
Off The module does not detect a link.
Flashing green The module is transmitting or receiving.
Off The module is not transmitting or receiving.
Green The log flash CompactFlash or USB disk is being accessed. Do not
remove the media until the LED is off.
Off The expansion flash CompactFlash or USB disk is not being accessed.
You can remove the media while this LED is off.
LEDs