Cisco Nexus 7702 Hardware Installation Manual page 32

Hide thumbs Also See for Nexus 7702:
Table of Contents

Advertisement

Installing the Chassis on a Four-Post Rack or Cabinet
Step 4
Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come in contact with the
vertical mounting rails on the rack.
Step 5
Use six screws (user preference from the accessory kit) at the front and four M3 screws at the back of the slide to secure
the system chassis to the four-post rack
Figure 7: Attaching the Chassis to the Rack
1
Install six screws (user preference from the
accessory kit) at the front.
Step 6
If you removed the fan tray before moving the chassis, reinstall each one in the chassis as follows:
a) Holding each of the two handles on the fan tray with your two hands, align the fan tray to an open fan tray slot.
The two alignment brackets on top of the fan tray should align to two tracks at the top of the
Note
slot.
b) Slide the fan tray into the slot until the front of the fan tray comes in contact with the rear of the chassis.
The two alignment pins on the fan tray (on the left and the right) should go into holes in the chassis and the
Note
two captive screws on the fan tray should align to screw holes in the chassis.
c) Screw in the two captive screws to the chassis and tighten each screw to 8 in-lb (0.9 N·m).
Step 7
If you removed any power supplies before moving the chassis, reinstall each one as follows:
a) Determine which power supply slots to fill and ensure that each of those slots is open.
If you are using the combined or power supply redundancy mode, you can use any slot for the power supply that you
are installing. If you are using input-source or full redundancy mode, you must group the power supplies that are to
be connected to the same grid on either the left or right power supply slots in the chassis.
Cisco Nexus 7702 Hardware Installation Guide
22
2
Install 2 sliders to the C-shape bracket on each side
of the chassis. Use four screws at the back of the slider
to secure the chassis to the four-post rack.
Installing the Switch Chassis

Advertisement

Table of Contents
loading

Table of Contents