Advertisement
Measuring Diode
1. Set the function switch to the green
2. Insert the black test lead banana plug into the negative
COM jack and the red test lead banana plug into the
V/Hz%/ /Cap/°C jack.
3. Press the MODE button to indicate "
display.
4. Touch the test probes to the diode under test. Forward
voltage will typically indicate 0.400 to 0.700V. Reverse
voltage will indicate "OL". Shorted devices will indicate
near 0V and an open device will indicate "OL" in both
polarities.
Audible Continuity Test
1. Set the function switch to the green
2. Insert the black lead banana plug into the negative COM
jack.
Insert the red test lead banana plug into the
V/Hz%/ /Cap/°C jack.
3. Press the MODE button to indicate"
display
4. Touch the test probe tips to the circuit or wire you wish to
check.
5. If the resistance is less than approximately 50:, the
audible signal will sound. If the circuit is open, the
display will indicate "OL".
20
position.
" and "V" on the
position.
" and " " on the
Advertisement
