Takagi 110 Outdoor Installation Manual And Owner's Manual page 38

510 model: 100112155 (TM-RE30)
<Set temperature>
1. Turn on the 120VAC power supply to the water
heater.
2. Press the "ON/OFF" button on the remote to turn
the remote controller on. It shows the time and
set temperature on the display as shown to the
right.
3. Press the "HOT" button or the "COLD" button to
set the temperature.
You can set the temperature from 100 °F (37 °C)
to 122 °F (50 °C).
Increasing temperature from 122 °F (50 °C) to 140 °F (60 °C)
Press the "HOT" button to set 122 °F (50 °C).
•
Press and hold the "INFO" button and the "HOT" button for at least 3 seconds. The remote will emit
•
a beep and change to 131 °F (55 °C).
Press the "HOT" button to set up to 140 °F (60 °C).
•
Increasing temperature above 140 °F (60 °C)
Press the "HOT" button to set 140°F (60°C).
•
Press and hold the "INFO" button and the "HOT" button for at least 3 seconds. The remote will emit
•
a beep and change to 158 °F (70 °C) or 149 °F (65 °C).
NOTE: The 149°F (65 °C) setting is available in high temperature mode. See below.
• Press the "HOT" button to set up to 167 °F (75 °C) or 176 °F (80 °C).
NOTE: The 176 °F (80 °C) setting is available in high temperature mode. See below.
The temperature options
The remote controller has two temperature range options: default mode and high temperature mode.
Default mode
°F 100 100 102 104 106 108 110 111 113 115 117 122 131 140 158 167
°C 37 38 39
High temperature mode (See below.)
°F 100 100 102 104 106 108 110 111 113 122 131 140 149 158 167 176
°C 37 38 39
<High temperature mode>
To change the remote controller's mode from default mode to high temperature mode, please follow the
procedures on the next page.
40 41 42 43 44
40 41 42 43 44
38
100112155 (TM-RE30)
"TIME"
"INFO"
"BUZZER"
45 46 47 50
45 50 55 60
Page
Owner's Guide
Normal Operation
"HOT"
"COLD"
"ON/OFF"
55 60 70 75
65 70 75 80