Subscribe to Our Youtube Channel
Related Manuals for Savaria Multilift CE
Summary of Contents for Savaria Multilift CE
- Page 1 Multilift CE VERTICAL PLATFORM LIFT INSTALLATION GUIDE Part No. 001423, Rev. 000 08-m11-2024...
- Page 2 ELECTRICAL SHOCK HAZARD Savaria Concord Lifts, Inc. is not responsible for any modifications of the product made by the user. Do not allow unqualified personnel to use equipment.
- Page 3 • ASME A17.1-1996 Section 21 (Private) operation of a product that has been modified from the • CAN/CSA B355 S1-02 (Public) original Savaria design. No person or company is authorized • CAN/CSA-B355-09 (Public) to change the design of this product without written authorization by Savaria.
-
Page 4: Table Of Contents
Adjust gate closer (as required) Verify operation Reverse automatic access ramp (if required) Before leaving job site Appendix A: Maintenance Appendix B Safety Checklist Appendix C Reference Drawings Appendix D One Touch Multilift CE Installation Guide Part No. 001423, 08-m11-2024... -
Page 5: Installation Flow Chart
(as required) Wind gate Reverse automatic Adjust gate Permanently install spring hinges access ramp Verify operation closer (as required) battery (batteries) (as required) (if required) Before leaving job site Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... -
Page 6: Double-Check Site Specifics
Ensure there are no fire and safety issues. Contact Savaria’s Technical Support at 1 (800) 791-7999 if there are any fire and safety issues. Verify there is adequate lighting at the landings. -
Page 7: Verify Cab Type (Handing)
Type 4 Type 3 panel as shown below. platform platform DANGER It is critical to recognize possible crushing or shearing Entrance Entrance (pinch) hazards and eliminate them. Figure 1 Shearing (pinch) hazard Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... - Page 8 Page 8 Figure 2 Sample plan drawing Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
-
Page 9: Power Up Lift For Installation
If the lift does not run, remove the panel in front of the controller and diagnose the problem electrically, referring to the wiring diagrams shipped with the lift. Connect the jumper wire for the power loss batteries for normal operation Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... -
Page 10: Anchor Lift To Pad/Floor
IMPORTANT IMPORTANT Anchors provided by Savaria are standard/typical anchors and are not suitable for all site conditions. Always make Anchors provided by Savaria are standard/typical anchors sure the anchors used are proper for the type of floor on and are not suitable for all site conditions. -
Page 11: Wall Support (Optional)
1.8 m (72”) Support bracket fixing to mast Procedure IMPORTANT Anchors provided by Savaria are standard/typical anchors and are not suitable for all site conditions. Always make sure the anchors used are proper for the type of floor on site. -
Page 12: Establish Landing Positions And Set Limit
Note that there is a lateral adjustment on the track and mounting bracket that supports the limit switches. This adjustment brings the switches closer to or further away from the platform cam. Double-check this adjustment. Multilift CE Installation Guide Part No. 001423, 08-m11-2024... -
Page 13: Install Landing Gate Or Door
Contact is required on the top landing only, the fold up ramp acts as a mechanical barrier to the platform gate. Gate Notch out landing so gate angle bracket is flush with vertical landing surface Landing Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... - Page 14 Phillips screws (107254 - 10-12x2” and 107255 - 10-12x3”). Wire the gate per the wiring diagrams shipped with the lift. Refer also to the landing gate harness drawings in Appendix B. Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
-
Page 15: Install Hall Calls (As Required)
Put the pin in place and remove the Allen key. Figure 26 Put pin in place and remove Allen key Repeat steps 1 and 2 to increase the tension. Repeat steps 1, 2 and 3 for the second hinge. Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... -
Page 16: Adjust Gate Closer (As Required)
To increase the gate closing speed, turn the closer rod counter-clockwise. This can be done while holding the wire and turning the rod manually or with pliers, as required. Multilift CE Installation Guide Part No. 001423, 08-m11-2024... -
Page 17: Verify Operation
(6 bolts). Figure 29 Remove automatic access ramp Reverse the position of the actuating arm from one side of the ramp to the other. Figure 30 Reverse position of actuating arm on ramp Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... -
Page 18: Before Leaving Job Site
Provide a copy of the Owner’s Manual and Warranty to the customer. Be sure to record all required details per the Owner’s Manual. Reinstall the underpan (eight screws). Reinstall the front panel and top cap. Multilift CE Installation Guide Part No. 001423, 08-m11-2024... - Page 19 Force to operate the manual lowering handwheel can be more than 30 N. Rotate the hand crank device in the desired orientation as indicated on the direction label to move the unit to the nearest landing. Part No. 001423, 08-m11-2024 Multilift CE Installation Guide...
-
Page 20: Appendix A: Maintenance
400 cycles at • Emergency lights on the COP cycle service) 50% depth of discharge in • Phone system (if equipped) cycle service) • Gate operators (if equipped) stay operational within landings. Multilift CE Installation Guide Part No. 001423, 08-m11-2024... - Page 21 • Gate operators (if equipped) stay operational within landings. NOTE To prevent possible corrosion on outdoor units, all metal surfaces (for example, stainless steel) should be cleaned and waxed regularly with the appropriate cleaner and wax. Part No. 001423, 08-m11-2024 Multilift CE Installation Guide...
-
Page 22: Appendix B Safety Checklist
(001433) • Multilift input/output drawing • Hall call - flush remote • Hall call -surface remote • Hall call - in frame • Landing gate harness • Hall call only gate harness Multilift CE Installation Guide Part No. 001423, 08-m11-2024... - Page 23 Page 23 Multilift CE input/output drawing MULTILIFT-CE ORGANIGRAM MULTILIFT-CE PCB SAFETY STRING CONTACTORS SAFETY1-1 P2-8 PIT SWITCH SAFETY1-2 CDN AUX P2-7 SAFETY1-3 P2-6 FINAL LIMIT UP SAFETY1-4 CDN AUX P2-5 SAFETY1-9 BELT MONITOR (IF INSTALLED) P2-4 SAFETY1-10 P2-3 P2-2 CUP AUX...
- Page 24 Page 24 Hall call - flush remote Description 328483 329388 Recommended Junction Box for Flush Mounted Remote 118x96x50 mm KLM-38002J Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
- Page 25 Page 25 Hall call - surface remote Description 328323 329391 Part No. 001423, 08-m11-2024 Multilift CE Installation Guide...
- Page 26 Page 26 Hall call - in frame Description 328481 329385 Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
- Page 27 AND MAY NOT BE USED BY OTHERS WITHOUT PRIOR WRITTEN CONSENT MATERIAL: DRAWN BY: DRAWN DATE: DRAFTSPERSON: TITLE: UNIVERSAL VERT. CONTROLLER C. QUIRK 07/02/24 SIZE CALL ONLY LANDING FINISH: DRAWING NO: SHEET CONNECTION DIAGRAM UVER-LANDING CALL Part No. 001423, 08-m11-2024 Multilift CE Installation Guide...
- Page 28 AND MAY NOT BE USED BY OTHERS WITHOUT PRIOR WRITTEN CONSENT MATERIAL: DRAWN BY: DRAWN DATE: DRAFTSPERSON: TITLE: UNIVERSAL VERT. CONTROLLER C. QUIRK 07/02/24 SIZE CALL/SEND LANDING FINISH: DRAWING NO: SHEET CONNECTION DIAGRAM UVER-LANDING CALL SEND Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
- Page 29 AND MAY NOT BE USED BY OTHERS WITHOUT PRIOR WRITTEN CONSENT MATERIAL: DRAWN BY: DRAWN DATE: DRAFTSPERSON: TITLE: UNIVERSAL VERTICAL CONTROLLER C. QUIRK 04/12/24 SIZE COMMANDER LANDING FINISH: DRAWING NO: SHEET CONNECTION DIAGRAM UVER-LANDING-COMMANDER Part No. 001423, 08-m11-2024 Multilift CE Installation Guide...
- Page 30 AND MAY NOT BE USED BY OTHERS WITHOUT PRIOR WRITTEN CONSENT MATERIAL: DRAWN BY: DRAWN DATE: DRAFTSPERSON: TITLE: UNIVERSAL VERTICAL CONTROLLER C. QUIRK 04/12/24 SIZE GATEKEEPER LANDING FINISH: DRAWING NO: SHEET CONNECTION DIAGRAM UVER-LANDING-GATEKEEPER Multilift CE Installation Guide Part No. 001423, 08-m11-2024...
-
Page 31: Appendix D One Touch
Page 31 Appendix D One Touch Refer to one touch manual document • Part No. 001423, 08-m11-2024 Multilift CE Installation Guide... - Page 32 Multilift CE Vertical Platform Lift INSTALLATION GUIDE Part No. 001423, Rev. 000 © Copyright 2024 Savaria Concord Lifts, Inc. www.savaria.com Support 2 Walker Drive Brampton, Ontario, L6T 5E1, Canada Toll free: (800) 791-7999 Fax: (905) 791-2222...
Need help?
Do you have a question about the Multilift CE and is the answer not in the manual?
Questions and answers