Eurotherm TC3001 User Manual page 45

Transit Inspector Pro
2. Open Computer object properties (see
parameter:
Disks to store archive
for ).
C
3. Create the required number of the Video Capture Device object (see
Guide) due to the type and number of cameras controlled from the very server.
4. Create Camera object with the following parameters:
Channel number
is attached to.
Resolution it is recommended to set the
Pre-recording phase duration
5. Create Database object (see
records and retention period optionally. Make sure that the server
for work with the external IP addresses.
6. Choose the Computer object that corresponds to the number recognition server.
Note: Procedure of the number recognition server configuration is similar for all recognition servers.
7. Create the Transit: number recognizer object (see
with the following parameters:
Analyse video from camera
Synchronously record video from cameras
Video recording mode
Recognize numbers of wagons incoming from
the task.
Redirect results to
current recognizer is not a main one.
Number detection and speed estimation
(see 4.2.3.2.1 Visually Setup Recognizer Parameters Utility
of number detection area.
8. Create the Transit: assisting recognizer object (see
page 36) with the following parameters:
Analyse video from camera
Synchronously record video from cameras
Video recording mode
Recognize numbers of wagons incoming from
the task.
Redirect results to
current recognizer is not a main one.
46
Administrating Module
SecurOS Administration
set access for video for at least one hard disk (e. g.
Read/Write
set the actual number of the labeled BNC connector the first camera
High (CIF2)
set approximate train passing time (s) by camera view.
4.2.2 Database on page 24). Define database for recognized number
4.2.3 Transit: number recognizer
define the corresponding Camera object.
select the proper recording mode.
define the Database object or enable the Consolidator field if the
define the corresponding Camera object.
select the proper recording mode.
define the Database object or enable the Consolidator field if the
www.isscctv.com
User Guide
Guide) and setup the following
SecurOS Administration
value.
PostgreSQL
define additional cameras to record video.
select the proper checkboxes due to
type in manually or set by the utility
on page 33) the parameters
4.2.4 Transit: assisting recognizer
define additional cameras to record video.
select the proper checkboxes due to
DBMS was set
on page 25)
on