Server-Workstation Configuration - Eurotherm TC3001 User Manual

Transit Inspector Pro
X — , Y — , W —
0 0
11. Create Transit: operator GUI object. Set the following parameters:
Display settings
Monitor object to display operator interface.
Number window: X —
Protocol window: X —
Display ... last trains
Enable searching
Allow number editing
12. Exit the administration mode.

4.3.2 Server-Workstation Configuration

1. Open the Computer object properties (see
ing parameter:
Disks to store archive
for ).
C
2. Create Video Capture Device object (see
3. Create Camera object with the following parameters:
Channel number
is attached to.
Resolution
Pre-recording phase duration
4. Create Sensor object (see
condition on train passing by (on sensor applying for train partition).
5. Create Database object (see
records and retention period optionally.
6. Create the Transit: number recognizer object (see
with the following parameters:
Analyse video from camera
Synchronously record video from cameras
Video recording mode
Recognize numbers of wagons incoming from
the task.
Redirect results to
current recognizer is not a main one.
43
Administrating Module
, H — .
60 60
select recognizers to display its results. For each object set the
, Y — , W —
0 60
, Y — , W —
60 0
set number of trains to display in Protocol window.
select the checkbox to allow operator to search in database.
select the checkbox to allow operator to edit recognized number.
SecurOS Administration
set
Read/Write
SecurOS Administration
set the actual number of the labeled BNC connector the first camera
set value.
High (CIF2)
set approximate train passing time (s) by camera view.
4.2.3 Transit: number recognizer
4.2.2 Database on page 24). Define database for recognized number
define the corresponding Camera object.
select the proper recording mode.
define the Database object or enable the Consolidator field if the
www.isscctv.com
, H — ;
60 40
, H — ;
40 100
Guide) and setup the follow-
access for video for at least one hard disk (e. g.
Guide).
on page 25) and define Alarm
4.2.3 Transit: number recognizer
define additional cameras to record video.
select the proper checkboxes due to
User Guide
on page 25)