Eurotherm TC3001 User Manual page 29

Transit Inspector Pro
Property
Number scan area
Speed estimation area
Use monitor for settings
visualisation
Set up using utility
Localizer performance
Camera position
Side
Camera reads numbers of
Lenght of car part visible
in video frame (meters)
Train speed limit
The figures below (figures 15–17) shows the examples of setting wagon number area.
30
Administrating Module
Description
Set a number localizator line position, i. e. top and bottom borders
of the number detection area (see figures
Set top and bottom borders of the train estimate area. The area
should always be within the train area (see figures
Select a monitor to check the defined parameters.
Click this button to open the Visually setup recognizer parame-
ters utility (see 4.2.3.2.1 Visually Setup Recognizer Parameters
Utility on page 33).
Warning: before running the utility is is necessary to eliminate
distortion (see below)!
Choose the required quality of the localization.
Select from the list a train side (relative to its moving) where the
camera is established.
Select from the list the train type which numbers will be read.
Set a wagon part lenght visible in the frame (in meters). Uses
in algorithms of speed estimation, division train to wagons and
maneuvering accounting.
Set the maximum permissible train speed.
Figure 15: Optimum carriage number rectangle
www.isscctv.com
User Guide
(continued from previous page)
18 – 20).
21 – 23).