Using The Device To Log In To A Telnet Server - HP 5920 series Fundamentals Configuration Manual

Step
8. Set the size of
command history
buffer.
9. Set the session idle
timeout.
10. Specify a command to
be automatically
executed when users
log in to the user lines.

Using the device to log in to a Telnet server

You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 8 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Step
1. Enter system view.
2. (Optional.) Specify the
source IPv4 address or
source interface for
outgoing Telnet packets.
3. Exit to user view.
Command
history-command max-size
value
idle-timeout minutes
[ seconds ]
auto-execute command
command
Command
system-view
telnet client source { interface
interface-type interface-number | ip
ip-address }
quit
30
Remarks
By default, the buffer saves 10 history
commands.
By default, the session idle timeout is 10 minutes
for all user lines.
If there is no interaction between the device and
the user within the idle timeout, the system
automatically terminates the user connection on
the user line.
If you set the idle timeout to 0, the session will not
be aged out.
By default, no automatically executed command
is specified.
Remarks
N/A
By default, no source IPv4
address or source interface is
specified, and the primary IPv4
address of the outbound
interface is used as the source
address for outgoing Telnet
packets.
N/A