Troubleshooting - Genie CCTV DN83TSPX Instruction Manual

■ Troubleshooting

If you have trouble operating your camera, refer to the following table.
If the guidelines do not enable you to solve the problem, contact an
authorised technician.
Problem
• Check the power connections.
Nothing appears on
the screen.
• Check the VIDEO signal line connection.
• Make sure the lens is clean. Clean the lens with
a soft clean lint free cloth.
The image on the
• Adjust the monitor contrast & brightness controls.
screen is dim.
• Re-position the camera if necessary.
• Adjust the contrast control of the monitor.
The image on the
• If you have an intermediate device, set the 75Ω
screen is dark.
/ Hi-z properly.
The camera is not working
• Check that an appropriate power source is
properly, and the surface
connected to the camera.
of the camera is hot.
The Motion Detection
• Check that MOTION DET in the SPECIAL
function does not
SETUP is not set to 'OFF'.
work.
PIXIM True Day/Night Bodied Camera
Solution
36
Problem
Colour is not correct. • Check the WHITE BAL settings in the SETUP menu.
The screen flickers
• Check that the camera is not facing toward the
continually. sun.
RS-485 • Check the polarity between the RS-485 Control
Port and the RS-485 cable.
communication fails.
485 Control Board Connection Port
(+) CONNECTION TERMINAL (TRX+)
(-) CONNECTION TERMINAL (TRX-)
• Check the RS-485 Communication default settings.
* RS-485 Communication default settings are :
Item
Initial value
Solution
RS-485 Control Port
485+
485-
Camera ID BAUD RATE
1 2400
37
PIXIM True Day/Night Bodied Camera