Operational - Fujitsu Libra S6 Operator's Manual

Chapter 7 Troubleshooting
Scanning does not start.
Is the document loaded in the ADF paper chute (feeder)
correctly?
Yes
Is the ADF closed properly?
Yes
Is the USB cable connected properly?
Yes
Is the connector on the USB cable broken or damaged?
No
Does scanning start after turning the scanner off then back
on?
No
Reload the document in the ADF paper chute (feeder).
No
Close the ADF firmly.
If the document is caught in the ADF, remove the document and close the ADF.
No
Connect the USB cable properly.
For details, refer to the Quick Installation Sheet.
No
Use a new cable and make sure that it is connected properly.
Yes
The scanner is operating correctly.
Yes
If the problem persists, check the items in
Service Provider" (page 85)
authorized FUJITSU scanner service provider.
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or an
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
72