Operational - Fujitsu Libra S6 Operator's Manual

Chapter 7 Troubleshooting
Device Errors
The following are lists of device errors which require troubleshooting by a service engineer.
LED [Power]
Indicator Button
Flashes 7 Lights up
times
Flashes 3 Lights up
times
Flashes 4 Lights up
times
Flashes 6 Lights up
times
Flashes 7 Flashes 7
times times
Flashes 3 Flashes 3
times times
Flashes Lights up
(continuously)
Item
An optical error (ADF front or
flatbed) occurred.
An optical error (ADF back)
occurred.
A flatbed motor error occurred.
An EEPROM error occurred.
A memory error occurred.
An LSI error occurred.
An error not mentioned above
occurred.
1 Clean the glass sections or the document bed.
For details, refer to "Chapter 5 Daily Care" (page
2 Turn the scanner off then back on.
If the problem persists, write down the status of the LED indicator and the
[Power] button and contact your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
Turn the scanner off then back on.
If the problem persists, write down the status of the LED indicator and the
[Power] button and contact your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
Action
49).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
69