Healthrider HMEL50708 User Manual page 9

7. The Console (17) can use four D batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the battery cover, insert the
batteries into the battery compartment, and
reattach the battery cover. Make sure to orient
the batteries as shown by the diagram
inside the battery compartment. Do not com-
bine old and new batteries or alkaline and
rechargeable batteries.
To purchase an optional AC adapter, contact
the store where you purchased this product
or see the cover of this manual. To avoid
damaging the console, use only a manufac-
turer-supplied AC adapter. Plug one end of
the AC adapter into the jack on the console;
plug the other end into an outlet installed in
accordance with all local codes and ordinances.
8. Have another person hold the Console (17)
near the Upright (2). Connect the Wire Harness
(42) to the wire harness on the Console. Then,
connect the Pulse Wire (20) to the pulse wire
on the Console.
Insert the excess wire downward into the
Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (17) to the Upright (2) with four M4 x
16mm Screws (72).
9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
7
Battery
Cover
8
Avoid pinching
the wires
Pulse Wire
2
72
72
9
17
Batteries
17
20
Wire Harness
42