Healthrider HMEL50708 User Manual page 6

1.
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
Identify the Front Stabilizer (8), which has
Wheels (40) attached.
While another person lifts the front of the Frame
(1) and holds the Pedal Legs (4, 5) in the posi-
tion shown, slide the Front Stabilizer (8) onto
the Frame.
Attach the Front Stabilizer (8) to the Frame (1)
with four M8 x 44mm Patch Screws (84).
While another person lifts the rear of the
Frame (1), attach the Rear Stabilizer (not
shown) to the Frame in the same way.
2. Have another person hold the Upright (2) near
the Frame (1).
See the inset drawing. Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the Wire Harness (42). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: To prevent the Wire Harness from
falling inside the Upright, secure the Wire
Harness with a rubber band.
Tip: Avoid pinching the Wire Harness (42).
Insert the Upright (2) into the Frame (1).
Attach the Upright (2) with four M10 x 20mm
Patch Screws (70) and four M10 Split Washers
(73). Do not tighten the Patch Screws yet.
1
1
40
84
2
2
73
70
73
70
6
4, 5
8
84
42
Avoid pinching the
Wire Harness (42)
70
73
Wire Tie
1
42