Healthrider HMEL50708 User Manual page 7

3. Slide a Weld Spacer (28) onto the axle on the
left side of the Upright (2). Make sure that the
open side of the Weld Spacer is facing the
Upright.
Apply a small amount of the included grease to
the axle and to a 5/8" Wave Washer (31).
Slide an Upper Body Arm (29) onto the axle on
the left side of the Upright (2). Then, slide the
5/8" Wave Washer onto the axle on the left side
of the Upright.
Attach the Upper Body Arm (29) with an M8 x
20mm Patch Screw (86) and a 5/16" Washer
(68). Make sure that the 5/8" Wave Washer
(31) is on the axle.
Attach the other Upper Body Arm (29) to
the right side of the Upright (2) in the
same way.
4. Look inside a Cover A (26) and a Cover B (66)
set and locate the square tabs connecting the
two halves. Gently lift the tabs and disconnect
the halves.
Hold the Cover A (26) and the Cover B (66)
around the tube on the left side of the Upright
(2). Align the halves and press them together
until they lock.
Attach the other Cover A (26) and Cover B
(66) set to the right side of the Upright (2) in
the same way.
3
Grease
29
31
68
86
Grease
4
26
7
2
28
29
Axle
66
2
26
66