Healthrider HMEL50708 User Manual page 18

HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first see the instructions at the left and remove
the shields and the flywheel covers.
Next, see the drawing below. Locate the Reed Switch
(55). Turn the Pulley (38) until a Magnet (37) is
aligned with the Reed Switch. Loosen, but do not
remove, the indicated Screw (72). Slide the Reed
Switch slightly closer to or away from the Magnet, and
then retighten the Screw. Turn the Pulley for a
moment. Repeat these actions until the console dis-
plays correct feedback. Then, reattach the shields and
the flywheel covers.
72
37
38
55
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
setting, the drive belt may need to be adjusted. To
adjust the drive belt, first see the instructions at the
left and remove the shields and the flywheel covers.
39
76
Next, see the drawing above. Loosen the indicated
Jam Nut (76). Tighten the indicated Screw (74) until
the Drive Belt (39) is properly tightened, and then
retighten the Jam Nut (76). Then, reattach the shields
and the flywheel covers.
18