Supermicro SUPERSERVER 5018D-FN8T User Manual page 60

SUPERSERVER 5018D-FN8T User's Manual
ME Manufacturing Mode
Close JPME2 to bypass SPI flash
security and force the system to use the
Manufacturing Mode, which will allow the
user to flash the system firmware from
a host server to modify system settings.
BIOS Recovery
Close pins 2 and 3 of jumper JBR1 for
BIOS recovery. The default setting is on
pins 1 and 2 for normal operation. See
the table on the right for jumper settings.
USB Wake-Up
Use the JPUSB1 jumper to enable the
function of "System Waking-Up via USB
devices" for USB0/1. This jumper allows
you to "wake-up" the system by pressing
a key on the USB keyboard or by clicking
the USB mouse of your system. The
JPUSB1 jumper is used together with
the USB Wake-Up function in the BIOS.
Enable both the jumper and the BIOS
setting to enable this function. See the
table on the right for jumper settings and
connections.
BMC Enabled
JPB1 allows you to enable the BMC
(Baseboard Management Control) chip
and the onboard IPMI connection for
debugging purpose only. After the BMC
is disabled, IPMI health and remote
management functions are no longer
supported. See the table on the right for
jumper settings.
Note: Please aways keep BMC enabled
to make sure that the platform operates
reliably with the health monitor.
Manufacturing Mode
Pin#
1-2
2-3
Jumper Settings
Pin#
1-2
2-3
Pin#
1-2
2-3
Pin#
1-2
2-3
5-18
Jumper Settings
Definition
Normal (Default)
Manufacturing Mode
BIOS Recovery
Definition
Normal
BIOS Recovery
USB Wake-up
Jumper Settings
Definition
Enabled (Default)
Disabled
BMC Enabled
Jumper Settings
Definition
Enabled (Default)
Disabled