Supermicro SUPERSERVER 5018D-FN8T User Manual page 59

VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
PCI-E Slot SMB Enable
Use Jumpers I2C1/I2C2 to enable
PCI SMB (System Management
Bus) support to improve system
management for the onboard PCI-E
slot.
Watch Dog Timer Enable
Watch Dog (JWD1) is a system moni-
tor that can be used to enter LAN by-
pass default settings, reset the system
or enter NMI when the Timer expires.
Close pins 1-2 to reset the system if
an application hangs. Close pins 2-3
to generate a non-maskable interrupt
signal for the application that hangs.
Open all pins to enter LAN pair default
mode only. Watch Dog may be en-
abled in the BIOS Setup. The default
timer is around 5 minutes.
Management Engine (ME) Recovery
Use JPME1 to select ME Firmware
Recovery mode, which will limit resource
allocation for essential system operation
only in order to maintain normal power
operation and management. In the single
operation mode, online upgrade will be
available via Recovery mode. See the
table on the right for jumper settings.
Chapter 5: Advanced Motherboard Setup
VGA Enable/Disable
Pin#
1-2
2-3
PCI Slot_SMB Enable
Pin#
1-2
2-3
Pin#
1-2
2-3
Open
Pin#
1-2
2-3
5-17
Jumper Settings
Definition
Enabled (default)
Disabled
Jumper Settings
Definition
Enabled
Disabled (Default)
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
LAN pairs set to
default mode without
reset or NMI
ME Recovery
Jumper Settings
Definition
Normal (Default)
ME Recovery