Supermicro SUPERSERVER 5018D-FN8T User Manual page 56

SUPERSERVER 5018D-FN8T User's Manual
TPM Header/Port 80 Header
The JTPM1 header is used to connect
a Trusted Platform Module (TPM)/
Port 80, which is available from a
third-party vendor. TPM is a security
device that supports encryption
and authentication in hard drives.
It enables the motherboard to deny
access if the TPM associated with
the hard drive is not installed in the
system. See the table on the right for
pin definitions.
Overheat/Fan Fail LED
The JOH1 header is used to connect
an LED indicator to provide warnings
of chassis overheating. Refer to the
table on right for pin definitions.
Speaker (JD1)
On the JD1 header, pins 4-7 are used
for internal speaker. See the table on
the right for pin definitions.
Standby Power
The Standby Power header is located
at JSTBY1 on the motherboard.
See the table on the right for pin
definitions.
Trusted Platform Module Header (JTPM1)
Pin Definitions
Pin # Definition
1 LCLK
3 LFRAME#
5 LRESET#
7 LAD3
9 +3.3V
11 LAD0
13 NC
15 +3V_DUAL
17 GND
19 3.3V
OH/Fan Fail LED (JOH1)
Pin Definitions
Pin#
1
2
OH/Fan Fail LED
Status Definitions
State
Off
Solid
Speaker Connector
Pin Setting
Pins 1-3
Pins 4-7
Pin Setting
1
2
3
5-14
Pin # Definition
2 GND
4 No Pin
6 +5V (X)
8 LAD2
10 LAD1
12 GND
14 NC
16 SERIRQ
18 GND
20 NC)
Definition
3.3V
OH Active
Message
Normal
Overheat
Pin Definitions
Definition
Power LED
Speaker
Standby Power
Pin Definitions
Definition
+5V Standby
Ground
No connection