5 Configuring the UAP2105
----End
5.1.2 FE Direct Connection Mode
This describes how to configure the IP address of the AP and the connection of the router in FE
direct connection mode.
Prerequisite
l
l
Context
Figure 5-3
Figure 5-3 FE direct connection mode
5-4
If ...
Net Mode is set to ETHIP and AUTO
IP to ENABLE
Net Mode is not set to ETHIP or AUTO
IP to ENABLE
3.
Configure the AP. On the WebUI, choose Transfer Basic > NETMODE . Click
Mod and set Net Mode to ETHIP and AUTO IP to ENABLE.0
You have logged in to the WebUI. For details, see
The IP address of the computer is set on the 192.168.1.x network segment.
shows the FE direct connection mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Then ...
The configuration is complete. End the
operation.
NOTE
When an AP is delivered, Net Mode is set to
ETHIP and AUTO IP to ENABLE by
default. Therefore, in PPPoE route mode, it
is not necessary to configure the AP.
Go to 3.
Logging in to the
WebUI.
Issue 03 (2009-08-20)
UAP2105
User Guide