Replacing Oil Filter Cartridge For 90 Mm Depth Oil Pan - Kubota D1503-M Workshop Manual

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM
Replacing Oil Filter Cartridge (for 90 mm (3.5 in.) Depth Oil Pan)
[D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M]
[D1703-M-BG, V2003-M-BG,
V2403-M-BG]
CAUTION
• Be sure to stop the engine before replacing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge
G-16
G GENERAL
V2003-M-T-BG, V2203-M-BG,
Use only a KUBOTA
W1022423
KiSC issued 07, 2008 A