Replacing Oil Filter Cartridge For 124 Mm Depth Oil Pan; Checking Radiator Hoses And Clamp Bands - Kubota D1503-M Workshop Manual

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM
Replacing Oil Filter Cartridge (for 124 mm (4.88 in.) Depth Oil
Pan)
[D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M,
V2403-M-T]
[D1703-M-BG, V2003-M-BG,
V2403-M-BG]
CAUTION
• Be sure to stop the engine before replacing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge
Replacing Oil Filter Cartridge (for 90 mm (3.5 in.) Depth Oil Pan)
[D1803-M-DI, V2403-M-DI, V2403-M-DI-T]
CAUTION
• Be sure to stop the engine before replacing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge

Checking Radiator Hoses and Clamp Bands

1. Check to see if the radiator hoses are properly fixed every 200
hours of operation or every six months, whichever comes first.
2. If the clamp is loose, apply oil to the threads and retighten it
securely.
3. The water hose is made of rubber and tends to age. It must be
replaced every two years. Also replace the clamp and tighten it
securely.
(1) Upper Hose
G-19
G GENERAL
V2003-M-T-BG, V2203-M-BG,
Use only a KUBOTA
W1023046
Use only a KUBOTA
W1035283
(2) Lower Hose
W1029518
KiSC issued 07, 2008 A