Setting
Default
Operation mode is set to Frequency output
Setting
Default
Operation mode is set to Pulse output
Setting
Default
Operation mode is set to Status output or Digital input
Related
Only if parameter Simulation is set to Enabled, then the setting of this parameter will be
relevant.
Path
4.8.1.4
Relay (3)
4.8.1.4.1 Simulation
Description
Enables or disables simulation of channel 3 relay output.
Setting
Default
Related
Only if this parameter is set to Enabled, then the setting of parameter Simulation value will
be relevant.
Path
4.8.1.4.2 Simulation value
Description
Relay output value to be output when simulation is enabled.
FST030
Function Manual, 04/2017, A5E35693328-AA
0.0 Hz to 12500.0 Hz
1.0 Hz
0.0 pulses/s - 12500.0 pulses/s
0.0
0; 1
0
Maintenance and diagnostics → Simulation → Simulation inputs and outputs → Channel 3 -
input/output → Simulation value
Disabled; Enabled
Disabled
Maintenance and diagnostics → Simulation → Simulation inputs and outputs → Channel 3 -
relay → Simulation
Maintenance and diagnostics
4.8 Simulation
289