Fiber Optic Ethernet Ports - Siemens RUGGEDCOM i803 Installation Manual

Chapter 3
Communication Ports
RJ45 receptacles at either end. Ground loops can cause excessive noise and interference, but more
importantly, create a potential shock hazard that can result in serious injury.
Each port features a Speed and Link LED that indicates the state of the port.
LED
Speed
Link
The following is the pin-out for the RJ45 male connectors:
8
Figure 8: RJ45 Ethernet Port Pin Configuration
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with LC (Lucent Connector) connectors. Make sure the Transmit (Tx) and
Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Figure 9: LC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
12
State
Yellow
Off
Yellow (Solid)
Yellow (Blinking)
Off
1
1
Description
The port is operating at maximum speed
The port is not operating at maximum speed
Link established
Link activity
No link detected
Pin Name
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Section 4.4, "Copper Ethernet Port
2
Section 4.5, "Fiber Optic Ethernet Port
RUGGEDCOM i803
Installation Guide
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
Fiber Optic Ethernet Ports