Table of Contents
Advertisement
SV Electric Actuator
July 2017
Actuator Specifications
Table 1. Baumann Actuator Specifications
ACTUATOR TYPE
POWER FAILURE
ACTION
POWER CONSUMPTION
TRANSFORMER SIZE
TRAVEL
MATERIAL
ENCLOSURE RATING
INPUT SIGNAL
POWER SUPPLY
ELECTRICAL CONNECTION
AMBIENT TEMPERATURE
RELATIVE HUMIDITY RANGE
OUTPUT THRUST
VALVE STEM POSITION FEEDBACK OUTPUT
SHUTOFF CLASS
TRAVEL TIME
NOISE LEVEL
MANUAL OVERRIDE
POSITION INDICATION
SPLIT RANGE CAPABILITY
AGENCY APPROVALS
QUALITY STANDARD
WEIGHT
WARNING
Always wear protective gloves, clothing and eyewear when performing any installation operations to avoid personal
injury.
Personal injury or property damage caused by sudden release of pressure or bursting of pressure retaining parts may result
if service conditions exceed those for which the product was intended. To avoid injury or damage, provide a relief valve for
over pressure protection as required by government or accepted industry codes and good engineering practices.
Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
If installing into an existing application, also refer to the WARNING at the beginning of the Maintenance section in this
instruction manual.
CAUTION
This actuator is intended for a specific range of pressures, temperatures and other application specifications. Applying
different pressures and temperatures to the actuator could result in parts damage, malfunction of the actuator or loss of
control of the process. Do not expose this product to service conditions or variables other than those for which the product
was intended. If you are not sure what these conditions are you should contact your
Partner for more complete specifications. Provide the product serial numbers (shown on the nameplate) and all other
pertinent information.
2
Lock in last position
6 VA (class 2 power source)
Housing
YOKE Legs
CE (A), UL 60730-1A/-2 -14, CSA E60730-1:02 (CE approval for actuator only)
SVX24-MFT
Direct or Reverse
4 W
12.7 and 19.1 mm (0.50 and 0.75 inches)
Aluminum die cast and plastic casing
Aluminum
NEMA 2, / IP 54 UL Enclosure Type 2
2 - 10 VDC or 4 - 20 mA input signal
24 VAC or 24 VDC
3 ft, 18GA appliance cable, 0.5 inch conduit fitting
-30 to 50_C (-22 to 122_F)
5 to 95% RH, non-condensing
1500 N (337 lbf)
2-10 VDC (0.5 mA maximum)
Class IV or VI per ANSI/FCI 70-2 (Refer to Valve Technical Bulletin)
35 seconds
< 45 dB(A)
4 mm Hex Head
Travel Indicator on Yoke
Yes
ISO 9001
1.3 kg (2.9 lbs)
Instruction Manual
SVK24-MFT
Fail Open / Fail Closed
8.5 W
21 VA (class 2 power source)
1.6 kg (3.6 lbs)
Emerson sales office
or Local Business
D104170X012
Advertisement
Table of Contents
