Efficiency And Cooling Method; Ambient Conditions - ABB ACS 600 MultiDrive Safety And Product Information

ACS 600 MultiDrive – Technical Data
Efficiency and
Cooling Method

Ambient Conditions

Condition
Installation Site
Altitude
Air Temperature
Relative Humidity
Contamination
Levels
(IEC 721-3-3)
Atmospheric
Pressure
Vibration
(IEC 68-2-6)
Shock
(IEC 68-2-29)
Free Fall
A-22
Efficiency: Approximately 98 % at nominal power level and frequency.
For units equipped with IGBT supply unit approximately 96 %.
Cooling Method: Internal fan, flow direction from the bottom to the top
Environmental limits of the ACS 600 MultiDrive frequency converters
are given below.
Operation
installed for stationary use
Nominal output power at 0 to
1)
1000 m above sea level
2)
0 to +40 °C (IP 21/22/42)
2)
0 to +35 °C (IP 54R)
5 to 95 %
No condensation allowed. Maximum allowed relative humidity is 60 % in the presence of
corrosive gases.
No conductive dust allowed.
Boards without coating:
Chemical gases: Class 3C1
Solid particles: Class 3S2
Boards with coating:
Chemical gases: Class 3C2
Solid particles: Class 3S2
70 to 106 kPa
Max. 0.3 mm (2 to 9 Hz),
2
max. 1 m/s (9 to 200 Hz)
sinusoidal
Not allowed
Not allowed
1)
At sites over 1000 m above sea level, the maximum output current is derated as
follows.
I = I · (100 % - 1 % · (h - 1000 m)/(100 m) + 1.5 % · (40 °C - T
max N40C
where
h altitude above sea level
I ACS 600 nominal current at 40 °C
N40C
T maximum ambient temperature.
amb
Note: I I
max <
2)
If the ambient temperature is higher than +40 °C (+35 °C), the output capacity of the
ACx 600 decreases. The output current is calculated by multiplying the current given in
the rating table by the derating factor.
Storage
in the protective package
-
-40 to +70 °C
Max. 95 %
Boards without coating:
Chemical gases: Class 1C2
Solid particles: Class 1S3
Boards with coating:
Chemical gases: Class 1C2
Solid particles: Class 1S3
70 to 106 kPa
Max. 1.5 mm (2 to 9 Hz),
2
max. 5 m/s (9 to 200 Hz)
sinusoidal
2
Max. 100 m/s , 11 ms
250 mm (weight under 100 kg)
100 mm (weight over 100 kg)
and T < 40 °C. At 2000...4000 m optional "varistors" are needed.
N40C amb
Transportation
in the protective package
-
-40 to +70 °C
Max. 95 %
Boards without coating:
Chemical gases: Class 2C2
Solid particles: Class 2S2
Boards with coating:
Chemical gases: Class 2C2
Solid particles: Class 2S2
60 to 106 kPa
Max. 3.5 mm (2 to 9 Hz),
2
max. 15 m/s (9 to 200 Hz)
sinusoidal
2
Max. 100 m/s , 11 ms
250 mm (weight under 100 kg)
100 mm (weight over 100 kg)
))
amb
ACS 600 MultiDrive