Safety Instructions; Overview; Caution; Note - ABB ACS 600 MultiDrive Safety And Product Information

Overview

CAUTION!

Operation

ACS 600 MultiDrive
This chapter states the safety instructions that must be followed when
installing, operating and servicing the ACS 600 MultiDrive frequency
converters. If neglected, physical injury and death may follow, or
damage may occur to the frequency converter, the motor and driven
equipment. The material in this chapter must be studied before
attempting any work on, or with, the unit.
All personnel who will install or do maintenance shall be familiar with
the safety instructions before opening the door of the ACS 600
MultiDrive frequency converter cabinet.
When installed and used in accordance with instructions, the ACS 600
MultiDrive causes no risk to its associated environment.
ACS 600 MultiDrive is referred to as ACx 600 in this chapter.
The following notation is used throughout the manual:
Dangerous Voltage WARNING! warns of situations in which a high
voltage can cause physical injury and/or damage equipment. The
text next to this symbol describes ways to avoid the danger.
General WARNING! warns of situations which can cause physical
injury and/or damage equipment by means other than electrical. The
text next to this symbol describes ways to avoid the danger.
Electrostatic Discharge WARNING! warns of situations in which an
electrostatic discharge can damage equipment. The text next to this
symbol describes ways to avoid the danger.
Aims to draw special attention to a particular issue.

Note:

Gives additional information or points out more information available on
the subject.
The doors of the ACS 600 MultiDrive frequency converter must be kept
locked when the frequency converter is in operation.
The operator should be informed of the significance of the diagnostics.
In case of an alarm indication, possibly followed by tripping, the
operator should be able to decide whether part of the system should be
removed from operation or whether the system should be restarted
after resetting the alarm. In the event that part of the drive system is
taken out of service, the appropriate maintenance personnel should be
called to further investigate the problem.

Safety Instructions

1