Acs 600 Multidrive - Technical Data; Abbreviations - ABB ACS 600 MultiDrive Safety And Product Information
Aca 6xx sections 3 to 4300 kw
Hide thumbs
Also See for ACS 600 MultiDrive:
- User manual (109 pages) ,
- Hardware manual (94 pages) ,
- Installation manual (28 pages)
Table of Contents
Advertisement
Abbreviations
Supply Section
I
Total rms input current (continuous a.c.
1N
current)
Duty Cycle (10 s / 60 s)
I
Maximum base current with I
DCbase
60 % of I
.
DC
I
Short term rms overload d.c. current (allowed for
DCmax
10 seconds every 60 seconds)
I
DCmax
I
DCbase
10 s
Duty Cycle (1 min / 5 min)
I
Maximum base current with I
DCbase
60 % of I
.
DC
I
Short term rms overload d.c. current (allowed for
DCmax
one minute every 5 minutes).
I
DCmax
I
DCbase
1 min
I
Continuous d.c. current
DC
S
Rated apparent output power of the supply
N
section
P
Nominal output power (continuous active
N
power)
P
Regenerative braking power to mains
G
P
Power loss
loss
U
Nominal mains voltage
N
ACS 600 MultiDrive
ACS 600 MultiDrive – Technical Data
The abbreviations used in the following supply and drive section rating
tables are explained below.
. I
is
DCmax
DCbase
50 s
. I
is
DCmax
DCbase
4 min
Note 1: Drive section output currents are valid when output frequency is above 10 Hz.
Note 2: The ratings given correspond to voltage U
115 V.
Note 3: The limiting factor for P
either the autotransformer or the generator bridge current depending on the
configuration of the supply section.
Drive Section
I
Rated rms a.c. output current (= maximum
2N
continuous output current)
200 % Duty Cycle (10 s / 60 s)
I
Maximum base current with I
2base
nominal heavy duty output current.
I
Short term rms a.c. overload current (allowed for
2max
10 seconds every 60 seconds) i.e. maximum
output current
I
2max
I
2base
10 s
150 % Duty Cycle (1 min / 5 min)
I
Maximum base current with I
2base
I
Short term rms a.c. overload current (allowed for
2max
one minute every 5 minutes)
I
2max
I
2base
1 min
S
Rated apparent output power of the drive
N
section
P
Typical motor power. The power ratings in kW
N
apply to most IEC 34 motors.
U
Nominal mains voltage
N
N
in thyristor supply sections with autotransformer is
G
. I
2max
2base
50 s
2max
4 min
and fan supply voltage 230 V or
is the
A-1
Advertisement
Table of Contents
