Troubleshooting of cable connection
7.2.1 Power cable connection check
Check if the power cable is connected to the camera properly.
※ Check whether the output of the adaptor is regulated 12V DC 1A(for built-in IR LED model)
or 500mA(for No IR LED model)
7.2.2 Network cable(LAN Cable) connection check
Check whether the network cable is connected correctly.
[Caution] Use direct LAN Cable or cross cable according to network condition. (Refer to chapter
2 Video check)
① Cable check
[Direct Cable]
Hold each end of both side and check if same color's cable is connected to same location in
RJ45 jack or not.(Connection with IP sharing device or cable modem)
[Cross Cable]
Hold each end of both side and check whether 1, 2(Tx+, Tx-) and 3, 6(Rx+, Rx-) are cross or
not.(Connection with PC)
C.
A.
B.
D.
73