WeiderPro 395 User Manual page 7

3. Orient the Crossbar (25) so that the warning
decals (not shown) are on top.
Attach one end of the Crossbar (25) to the Left
Brace (26) with two M10 x 77mm Carriage
Bolts (53), a Support Plate (13), and two M10
Locknuts (44); do not tighten the Locknuts
yet.
Repeat this step to attach the Crossbar (25)
to the Right Brace (not shown).
Then, tighten the M10 Locknuts (44) used in
this step and in step 2.
4. Attach a Weight Storage Tube (29) to the Left
Brace (26) with an M10 x 25mm Screw (49) and
an M10 Washer (41).
Repeat this step to attach the other Weight
Storage Tube (not shown) to the Right
Brace (60).
5. Identify the Left Weight Rest (27).
Insert the Left Weight Rest (27) into the desired
hole in the left Upright (24), and rotate it to the
position shown in the inset drawing.
Attach the Left Spotter (28) to the left Upright
(24) in the same way.
Repeat this step to attach the Right Weight
Rest (58) and the Right Spotter (59) to the
right Upright (24).
Make sure that both Weight Rests (27, 58) are
at the same height and that both Spotters (28,
59) are at the same height.
3
53
25
53
4
60
5
58
24
59
7
26
49
41
26
24
27
28
13
44
29