Pc With Wi-Fi Adapter - D-Link DVG-N5402G/ACF User Manual

DVG-N5402G/ACF Wireless AC1200 Dual Band Gigabit Router
with Fiber WAN Port, 3G/LTE Support, 2 FXS Ports, 1 PSTN
(lifeline) Port, and USB Port
User Manual

PC with Wi-Fi Adapter

1. To connect via USB modem: connect your USB modem to the USB port
back panel of the router.
!
If you need to connect or change a USB modem to another one when the router is powered
on, power off the device, connect the modem to the USB port, and power on the router.
2. To connect the device to a fiber optic line: connect your SFP transceiver to the SFP port,
then connect the fiber optic cable to the SFP transceiver.
3. To connect the device to an Ethernet line: in the web-based interface of the router, select
the router's LAN port that will be used as the WAN port and create an Ethernet WAN
connection. Then connect an Ethernet cable between an available Ethernet port of the router
and the Ethernet line.
!
Please connect the router to the ISP's Ethernet line only after setting the WAN port and
creating the Internet connection.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Turn on your PC and wait until your operating system is completely loaded.
7. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in wireless NICs are
equipped with a button or switch that turns on/off the wireless adapter (refer to your PC
documents). If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.
9 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 30 of 259
Installation and Connection
9 located on the