D-Link DVG-N5402G/ACF User Manual page 223

DVG-N5402G/ACF Wireless AC1200 Dual Band Gigabit Router
with Fiber WAN Port, 3G/LTE Support, 2 FXS Ports, 1 PSTN
(lifeline) Port, and USB Port
User Manual
Parameter
Flash type
Dial delay time
Enable internal calls
Enable NAT support
Voip dialplan setting
Content type for flash
button
Enable T38 support
Enable V.152 support
The FLASH action type.
Transfer: switching between calls.
•
SIPInfo: sending a service message to the SIP server.
•
The delay time before the next digit is dialed (from 3 to 9 seconds).
When this time expires, the router regards that the dialing is
completed and sends the request to the server. Select a needed value
from the drop-down list.
Select the checkbox to allow calls from the phones connected the
FXS ports pass through the router without the SIP server.
Select checkbox to allow the router to support the state of
automatically forwarded ports by periodic exchange of service
messages. In the NAT support interval field specify the time
interval between service messages.
The dial plan for VoIP. You can specify several rules separated by
the character | (vertical bar).
For specifying the rules you can use the following characters:
[] – a range of values for a certain position in the number. You can
specify one rage, several ranges separated by a comma, or several
digits.
X – any digit.
. – arbitrary number of any digits or no digits.
T# – additional time before dialing. # is mandatory. It can take
values from 0 to 9. This parameter should be the last two characters
of the dial plan. When the parameter is not specified, it is assumed
that T=0 for all dial plans.
If the SIPInfo value is selected from the DTMF relay setting
drop-down list, you can select the type of data transferred in SIP
INFO messages.
Fax settings
Select the checkbox to allow support of the T.38 protocol. When the
checkbox is selected, the T.38 section is displayed on the page.
Select the checkbox to allow support of the V.152 recommendation.
When the checkbox is selected, the V.152 section is displayed on
the page.
Page 223 of 259
Configuring via Web-based Interface
Description