Table of Contents
Advertisement
Light Palette Lighting Control Console
28. Time
Time
• After pressing [CUE] number, the Cue Time for the cue can be entered on the command line.
29. Tools
Tools
• Press [SHIFT] [TOOLS] to change the softkeys to the available tools. Select a tool ([S12] gives more options). Ini-
tiates softkey tool functions such as flip, channel check, flash, etc.
• If the LED is on, the tool is active. Press the button to turn off the tool.
• Pressing and releasing this button when the LED is off will toggle the last selected tool on.
Note: The status area at the bottom of the screen shows the current active tool.
30. Up / Down
Up
Down
• Use these buttons to raise or lower the selected channel's intensity by the pre-determined level in [S2] "Show
Options."
• Use with [SHIFT] to move the selected channel's intensity one percentage point.
• In dialogue boxes, these buttons will raise or lower number boxes by pre-determined levels (cue number by 10,
time by 10, SMPTE by 1 minute etc.).
31. Update
Updt
• When making changes live, press [UPDATE] [ENTER] to update the current cue with the changed levels.
[SHIFT][UPDATE] will open the update dialogue box for increased information on what can be updated based on
what has changed.
• If you have changed tracking levels or palettes, you can select different items from the list to update (i.e. Track
Back and Palette Update).
• If you have used the [LOAD] button to load a Cue or Look, once you make the changes, press [UPDT] to store the
changes and release any selected channels. (You will not be able to use this button if you did not use All Attributes
during your load operation.)
Installation & Setup Guide
37
Button Details
Advertisement
Table of Contents
