Table of Contents
Advertisement
Light Palette Lighting Control Console
13. Load
Note: For those familiar with previous Strand Lighting Consoles, this does not work like the 500 Series of consoles
to load a cue on a playback.
• Unlike previous Strand consoles, Load will activate the recorded item's information for editing. [LOAD] [CUE]
[1] [ENTER] will place all contents of cue 1 into either the Live editor (if in Live Mode) or the Blind editor (if in
Blind Mode). Channel information can be edited and then updated.
• If in the dialogue box, press [S4] to load the entire state of the cue (all the cumulative levels that got you to the
Look on stage at that point in the Cue List).
• Edit the cue by changing levels, adding channels or releasing channels.
• Either press [UPDT] to update the loaded cue (watch the status area at the bottom of the screen) or press [REC] to
record it as a new Cue or Look.
• Press [LOAD] [LOOK] then the desired Look number to load a Look for editing.
14. Look
Look
• A Look is a location for a stored state that can be accessed as groups, submasters or palettes. Set channels at levels,
then type [REC] [LOOK] [1] [ENTER]. This will store the info as Look 1 and it will be accessed as Submaster 1.
• Alternately, you can set them to a level using the keypad by typing [LOOK] # @ Level [ENTER]. Attributes will
always go to their proper recorded level.
• Press [REC] or [SHIFT] [REC] then a bump button to quickly record a Look to a submaster.
• Groups are stored as Looks, even if the levels are not used.
15. Move
Move
• Although you can move cues from one Cue List to another while working in one Cue List, moving cues is essen-
tially renumbering cues. Highlight the cues you want to renumber with the blue box, then press [MOVE] [NUM-
BER] [ENTER] to renumber the selected cue(s) to new cue(s).
• While the Move dialogue box is open, you can also select a new numbering scheme.
• Press [MOVE] [LOOK][#] [@] [#] [ENTER] to move Looks.
• Press [SHIFT] [MOVE] [BUMP][BUMP] to quickly move Looks.
• Use [#] [MOVE] [#] [ENTER] to move attributes from one channel to another.
Installation & Setup Guide
31
Button Details
Advertisement
Table of Contents
