Table of Contents
Advertisement
Light Palette Lighting Control Console
7. Edit
Edit
• Pressing the [EDIT] button allows changes to the highlighted cells in the Cue List or Look display (times, labels,
follows etc.) or in the patch displays. Move the blue highlighted cells using the [ARROW KEYS].
• If a range is selected, typing in a new value will change all cells to that value.
• If editing a numeric column (such as Time), after pressing [EDIT] use the level wheel to change the values. If mul-
tiple cells are selected, the values will change relative to each other. In the example below, if the wheel is used to
change the '3' to a '4', the '2' would change to a '3' and the '1' would change to a '2'.
• Holding down [SHIFT] while rolling the level wheel while editing cells will change numeric values by 0.1.
8. Follow
Flw
• Follow allows the next cue in sequence to be triggered automatically after a set time. For example, [CUE] [1]
[FLW] [5] [ENTER] will allow cue 2 (assuming that cue 2 is the next cue after cue 1) to begin 5 seconds after cue
1 begins. More advanced follow times can be set in the action dialogue box. Just press [EDIT] with the blue box
under the action column of any cue.
9. Go
Go
• Go will begin running a cue in the recorded time. Note: The [SELECT] button does not have to be active (amber
LED flashing).
• If a cue is running, the Green LED will be flashing.
• If you are sitting in a cue, the LED will be solid Green.
• If the Cue List is releasing, both the [GO] and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] [GO] asserts the Cue List, grabbing full control of its attributes without advancing the Cue List.
Installation & Setup Guide
29
Button Details
Advertisement
Table of Contents
