Table of Contents
Advertisement
Installation & Setup Guide
22. Release Playback
Rel-
PB
• Pressing the [REL-PB] button will release the Cue List on the selected playback master. The cue pointer will
remain at the current cue position, therefore pressing [GO] will put you back into the same state you were in before
you hit [REL-PB].
• Press [SHIFT] [REL-PB] to release all Cue Lists.
• Press and hold [REL-PB] and a [SELECT] button to release that Cue List and not change your currently viewed
Cue List.
23. Rem Dim
Rem
Dim
• Use [REM DIM] as part of the command line to switch all other channels to a level of 0%. For example, [1] [/] [50]
@ [FL] brings channel 1-50 at 100%. Then pressing [25] [REM DIM] will take all channels except channel 25 to
0% while leaving 25 at 100%.
• If you are running two Cue Lists, the first [REM DIM] press only dims the channels on the Cue List you have
selected - the second press would [REM DIM] all remaining Cue Lists.
24. Select
Select
• Press a [SELECT] button to determine which Cue List cues will be written to by default when you record cues.
The 'selected' Cue List will have an amber LED flashing. Other playbacks that have Cue Lists assigned to them
will have solid amber LEDs.
• Pressing this button is the same as using the mouse to highlight a Cue List in the Cue List directory.
• To quickly record cues to a Cue List (even if it is not the currently selected Cue List) press [SHIFT] [REC] then
[SELECT]. The new cue will be appended to the end of the Cue List and the current Cue List selection will not
change.
3 4
Controls
Light Palette Lighting Control Console
Advertisement
Table of Contents
