Table of Contents
Advertisement
Light Palette Lighting Control Console
HOOK-UP
1. Connecting Console Components
To connect console components, do the following:
Step 1. At console rear panel, connect power supply (included).
Step 2. Connect monitor or touchscreen (sold separately).
Step 3. Install gooseneck lamps (sold separately).
Step 4. Connect USB-compatible peripherals (i.e. mouse, keyboard, etc.) as needed.
Gooseneck
(XLR-3F)
MIDI/SMPTE Card
Expansion Slot
2. DMX512 Output
The console provides four standard XLR 5-pin connectors for connecting to DMX512 devices. Each connector
supports one DMX512 universe of 512 DMX channels. Connect DMX512 devices as shown in Figure 1.
3. External Trigger Input
The console provides a switch closure trigger input.
This connector supports any compatible device which
can trigger the dry contact closure. The trigger function
is user-configurable using the PaletteOS software
interface. The trigger input connector is wired as shown
in Figure 2.
Trigger setup is done via [S3] Hardware Setup. Refer to
PaletteOS software Help Menu for details.
B
C
D
A
DMX512 Out
(XLR-5M)
External
Trigger
Input
Figure 1: Console Rear Panel
Processor
PROCESSOR DETAIL
Monitor (HDB-15F)
Monitor
Power
(HDB-15F)
Figure 2: External Trigger Connection
Installation & Setup Guide
Gooseneck
(XLR-3F)
Serial (DB-9M)
Network
(RJ-45)
Audio (2)
USB (2)
Triggering
Trigger 1
Short pins 1 & 2
Trigger 2
Short pins 1 & 3
Trigger Connections
Pin
Description
1
Common
2
Trigger 1
3
Trigger 2
Hook-Up
11
Advertisement
Table of Contents
