Making Connections - Radial Engineering BASSBONE OD User Manual

®
Start by setting the controls on your bass amp so that they are fl at and the
controls on the Bassbone OD to the 'start' position as shown below. Set
all the recessed function switches on the sides to their outward position.
Outward positions
Set the controls as shown and check that all seven recessed
switches on the sides are set to their outward position.

MAKING CONNECTIONS

Before making connections, always ensure your stage amp and audio
system levels are turned down. This will avoid loud power-on or plug-in
transients from damaging sensitive components like loudspeakers. There
is no power switch on the Bassbone OD. When you connect the 15VDC
power supply it will spring to life and the LEDs will illuminate to let you know
power is on. A cable clamp next to the power jack can be employed to
prevent accidental disconnection. Loosen the clamp, pass the power cable
through and re-tighten.
Connect your electric bass to INPUT-A. Connect the ¼" OUTPUT jack to your
bass amp. The A/B select switch toggles your bass between channel-A and
channel-B. Make sure channel-A is selected, the green LED will illuminate.
Start by testing the audio to make sure everything is working. Increase
the GAIN on channel-A to about the 2 o'clock position. Slowly turn up the
volume on your bass amp. It is a good practice to test at a low volume level
should a faulty cable or other problem be encountered.
Radial Engineering Ltd.
7 o'clock position
(minimum)
5
True to the Music
Outward
position
12 o'clock
position
(50%)
Outward
position
Bassbone OD™