Overdrive - Radial Engineering BASSBONE OD User Manual

®
To use the effects loop, connect the SEND jack to the input of your pedal
chain and the output from your pedals to the RECV (receive) jack using
standard ¼" coaxial guitar cables.
You can activate the effects loop in one of two ways; you can assign it to
the OVERDRIVE footswitch or it can be active all the time. The 3-position
EFX switch lets you assign the effects loops to the left OVERDRIVE
footswitch by setting the switch to LOOP. Set this way, you can turn the
Bassbone's effects loops on and off with your foot. When the EFX switch
is set to DRIVE, the footswitch only activates the overdrive circuit. Finally,
the BOTH setting activates the overdrive circuit and the effects loop.
The recessed LOOP ON switch on the left side sets the effects loop so
that it remains active at all times. When the LOOP ON switch is set to
the inward position, the effects loop remains active and the OVERDRIVE
footswitch is dedicated to the Bassbone OD's overdrive circuit.
Radial Engineering Ltd.
ASSIGN FOOTSWITCH FUNCTION
BOTH Activates the overdrive and loop
DRIVE Activates the overdrive
LOOP Activates the loop
LOOP ON
10
True to the Music
180°
POLARITY
FOR LOOP
Bassbone OD™