Advertisement
Connections to be made
• Connect the Purple RCA to the right rear RCA output.
For BOSE systems:
• Connect the White RCA to the left front RCA output.
• Connect the Gray RCA to the right front RCA output
• Connect the Green RCA to the left rear RCA output.
• Connect the Purple RCA to the right rear RCA output
Note: It is highly recommended that the radio being used has 2 sets of RCA
outputs to retain balance and fade; 3 sets if a subwoofer amplifier will be
added.
(d) From the 12-pin harness (ASWC-1 pre-wired harness):
• This harness is to be used in conjunction with the optional ASWC-1 (not
included) to retain steering wheel controls. If the ASWC-1 is not being
used, disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
XSVI-9004-NAV
Installing the XSVI-9004-NAV
With the key in the off position:
• Connect the 12-pin harness into the interface.
• Connect the 16-pin harness into the vehicle.
• Connect the 26-pin harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
Note: If using the ASWC-1, connect it after you initialize the XSVI-9004-NAV, with
the key in the off position.
• If the vehicle has engine noise after installing the XSVI-9004-NAV, use Axxess
part number AX-AGL610, qty. (2).
Troubleshooting
Advertisement
