Advertisement
From the LD-AX-XSVI-AU2 harness to the aftermarket radio
(a) From the 12-pin harness:
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire, if the aftermarket radio has
no illumination wire, tape off the Orange wire.
The following wires are for aftermarket multimedia/navigation radios that provide
these wires (if not required, tape them off and disregard them):
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Connect the Blue/Pink wire to the speed sense (V.S.S.) wire (if applicable).
(b) From the 16-pin harness:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
For non-BOSE systems:
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
XSVI-9004-NAV
Connections to be made
(c)
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Tape off and disregard the following wires, they will not be used in
this application:
• The Green, Green/Black, Purple, Purple/Black wires.
For BOSE systems:
Tape off and disregard the following wires, they will not be used in
this application:
• The Green, Green/Black, Purple, Purple/Black, White, White/Black, Gray,
and Gray/Black wires.
From the 26-pin harness:
• Connect the Blue/White wire to the amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
For non-BOSE systems:
• Disregard the White RCA, it will not be used in this application.
• Disregard the Gray RCA, it will not be used in this application.
• Connect the Green RCA to the left rear RCA output.
Advertisement
