Mounting Kit - CDVI Galeo 2 Installation Manual

INSTALLATION MANUAL
GALEO
Weatherproof Illuminated Keypad with remote electronics

3] MOUNTING KIT

GALEO
Remote
Controller
4] MOUNTING
1
Verify the distance
GALEO keypad
electronic (Refer to page 2 «Notes and
Recommendations»). Place the back
plate of the GALEO on the wall and
the bracket of the remote electronic
then mark with a pen the hole location
then drill the 2 mounting holes (drill bit
Ø 5 mm and 35 MM hole depth)
and the hole wiring access.
4
® GALEO ®
ALEO
Fasten the GALEO keypad to the back
plate by using the supplied (M4x10)
Torx screw and T20 Trox spanner
®
hardware. Place the screw cap at the
bottom of the keypad.
(M4x10)
T20 Torx
®
Varistor
Torx
screw
1 1
- -
2
between the Insert the 2 plastic anchors in the
and its remote holes. Place the back plate of the
GALEO and screw on the wall using
the
screws.
5
Insert the 2 plastic anchors in the holes.
Place the bracket of the electronic
and screw on the wall using the supplied
M4x30 screws. Slide the box from up
to down on the bracket.
®
(M4x30)
Caps mounting
Spanner
screws
1 2 2
- - 2
®
GALEO
GALEO ®
GALEO ®
supplied (M4x30) mounting
Wiring Wiring
Plastic
sealed sealed
anchors
cap cap
2 - -
2 2 2
3
®
GALEO
GALEO ®
Insert the cable in the hole access
area of the back plate. Then mount
the keypad on the back plate,
placing first the top in the hooks
and then the bottom.
6
(x4)
(x4)
Insert the cable in the remote electronic
and wire the cable to the terminals.
Don not forget to install the varistor
on the lock (Refer to page 2 «Notes
and Recommendations»).
cdvigroup.com
EN
Mounting
plate for
remote
electronic
box
-
1
®
GALEO
(x4)
3