1
Port Link/Act and Speed LEDs
2
Power and Fault/Locator LEDs
1
Port Link/Act LEDs
2
Power and Fault/Locator LEDs
3
Mode LED
When the switch is powered on, it performs a diagnostic self test. The behavior of the LEDs is as follows:
During the self test:
•
Initially, the Power, Fault/Locator, and all port LEDs turn on.
•
After several seconds, the Power and Fault/Locator LEDs remain on, and the port LEDs turn off. Then
each port Link LED is sequentially turned on, then off.
•
The Fault/Locator LED turns off when the self test completes.
When the self test completes successfully:
18
Installing the Switch
2
1
3
2
1