Connect The Optional Digital Communication Output; Install A Secure Digital (Sd) Memory Card - Hach sc200 User Manual

Figure 11 Digital sensor quick connect
1.

Connect the optional digital communication output

The manufacturer supports Modbus RS485, Modbus RS232, Profibus DPV1 and HART
communication protocols. The optional digital output module is installed in the location indicated by
item 4 in Figure 7 on page 12. Refer to the instructions supplied with the network module for more
details.
For information about Modbus registers, go to
search Modbus registers or go to any sc200 product page.

Install a Secure Digital (SD) memory card

For instructions on how to install an SD card in the controller, refer to
to use the SD memory card can be found in
on page 42.
To remove an SD card, push down on the edge of the card and release, then pull the card up and out
of the slot. After the card is removed, close the slot cover and tighten the cover screws.
Figure 12 SD card installation
http://www.de.hach.com
Using the secure digital memory (SD) card
or http://www.hach.com
Figure 12. Information on how
English 21
and