Table of Contents
Advertisement
Surface Cooking
(continued)
Cooktop
To prevent the cooktop from discoloring or staining:
Burner Grates
Clean cooktop after each use.
The grates must be properly positioned be-
Wipe acid or sugar spills as soon as the cooktop has
fore cooking. Improper installation of the
cooled as these spills may discolor the porcelain,
grates may result in chipping of the
cooktop.
Do not operate the burners without a
Unlike a range with standard gas burn-
pan on the grate. The grate's porcelain
ere, this cooktop does not lift-up nor is it
finish may chip without a pan to absorb
removable. Do not attempt to lift the
the heat from the burner flame.
cooktopfor any reason.
Although the burner grates are durabie,
they will gradually lose their shine and/or discolor, due to
the high temperatures of the gas flame.
Sealed Burners
The sealed burners of your range are secured to the cooktop
Notes..,
and are not designed to be removed. Since the burners are
sealed into the cooktop, boilovers or spills will not seep un-
• A properly adjusted burner with clean ports will light
derncath the cooktop. However. the burners should be
within a few seconds. If using natural gas the flame
cleaned after each use. (See page I1 for cleaning directions.)
will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy the air/gas
mixture may be incorrect. Contact a service techni-
High Performance
Burners
(12,000
BTU*)
cian to adjust. (Adjustments are not covered by the
(select
models)
__..,___
warranty.)
Ranges with two high speed burners have
% g)'lllll'
With LP gas, some yellow tips on the flames are ac-
the burners located in the right front and
'11111'
'11111'
c eptable. This is normal and adjustment is not neces-
left rear positions. These burners offer
sary.
higher speed cooking that can be used to
'1111,
'lllll,
• with some types of gas, you may hear a "popping"
quickly bring water to a boil and for large-
_
sound when the surface burner is turned off. This is a
quantity cooking.
'[lll[' ( _
POWER
BOOST
normal operating sound of the burner.
• BTU ratings will vary when using LP gas.
• If the control knob is turned very quickly from HIGH
to WARM, the flame may go out, particularly if the
burner is cold. If this occurs, turn the knob to the
OFF position, wait several seconds and relight the
burner.
• Refer to page 13 to adjust the WARM setting, if
needed.
• The flame should be adjusted so it does not extend
beyond the edge of the pan.
Advertisement
Table of Contents
