Table of Contents
Advertisement
CARE INFORMATION
" _
Be sure the range is cool before removing any
To clean control knobs: !) Remove knobs by
parts or cleaning the unit. Any parts removed
gently pulling off. 2) Clean with warm soapy
in the cleaning should be replaced correctly,
water. 3) Do not use abrasive cleaning
agents for they will scratch
the finish and
remove markings. 4) Replace knobs.
COOKTOP AND GRATES
To clean grates: Grates are made of porcelain-
To remove cooktop: First remove grates,
coated steel and can be cleaned with warm
then grasp front two burner wells and lift up.
soapy water or in the dishwater. Use a soap-
Top can be completely
removed,
filled scouring pad for stubborn soil.
SURFACE
BURNERS
Shipping screws or packing protect surface
burner during transportation.
Once range is
installed, the screws or packing must be
removed.
To remove burner: 1) Remove cooktop.
2) Grasp burner head and tilt to release tab
from slot near ignitor or pilot. 3) Lift burner
_
up and toward rear of range until burner is
released.
To replace cooktop: Insert two pins on the
back of the cooktop into the holes in the
console. Lower into place applying pressure
at the front edges to secure top to the range.
To clean cooktop:
_--_'
1. All spillovers, especially acid spillovers,
should be wiped up as soon as possible
with a dry cloth. To prevent possible
cracking or chipping of the porcelain,
never wipe off a warm or hot surface
.[
with a damp cloth.
2. When surface is cool, clean with warm
To replace burner: 1) Insert the air shutter
soapy water,
end of the burner over the hood and lower
burner into place. 2) Insert tab on burner into
3. Do not use abrasive or caustic cleaning
slot in burner support located in burner box.
agents on the porcelain-enamel
finish for
If burner is not replaced correctly, cooking
they will permanently
damage the finish,
results will be affected,
burner will not
operate properly and a safety hazard could
occur. 3) Replace cooktop.
To clean burner box: 1) Remove cooktop. 2)
The burner box, located under the cooktop,
A natural dulling of the surface burner's
should be cleaned frequently with soap and
aluminum finish should be expected. This is
water to remove spillovers. If soil is not
a permanent dulling and will occur over a
removed and is allowed to accumulate, it may
period of time with continued
usage.
.._
" --\-
damage the porcelain-enamel finish. 3) If
Cleaning practices may improve the
\
desired, an application of appliance wax can
appearance
but will not completely
restore
be used to protect the finish of the burner box.
the finish to its original luster.
15
Advertisement
Table of Contents
